Configuring Object Storage
Admins can configure the Object storage from the services section. To configure the Object Storage service, follow these steps:
- Go to the Default Services in the primary navigation menu.
- Select "Object Storage" under the Storage section.
- Enable the switch present at the top, i.e., This service is available as part of default services. All the sections will be enabled.
- Go to the Availability section. Select the availability zones where you want to offer the service. Then click on Save & Update.
- Click on the Billing section; the following two options will be listed. i. Prorate on Entry and Prorate on Exit.
- Click on the Provisioning section to offer the Object Storage service as approval-based. Enable the approval required switch. Enabling the switch, you will get two more options, i.e., Custom instructions that you want to send to the end user upon approval; you can also attach a maximum of 5 files up to 3 MB.
- Click on the Storage under Pricing, Click on the AZ, and specify the pricing in GB/hr.
- Click on the Data section, click on the Availability Zone, and specify the pricing in GB/hr for both Data Rate in and Data Rate out.
- Click on the Requests section, select the availability zone, and specify the pricing for the below:
- HTTP requests GET/HEAD
- HTTP requests PUT/POST
- HTTP requests DELETE
- Return to the Default Services and click on "PUBLISH DEFAULT CATALOGUE."
Comments
0 comments
Article is closed for comments.